How to Use EBS Wax for Rust Removal

How to Use EBS Wax for Rust Removal

Rust is a common problem faced by many vehicle owners. Over time, metal components of automobiles can succumb to rust due to damage, wear, moisture or exposure to the elements. Unfortunately, rust not only makes a car look unsightly, but it can also weaken the structural integrity of the vehicle. If left untreated, rust might result in significant damage and costly repairs. That is why it is crucial to remove rust as soon as you notice it. One of the most convenient and effective ways to combat rust is using a product called EBS Wax. EBS Wax is a rust remover that can effectively dissolve rust, leaving behind a protective coating to prevent rust from recurring.

Here is a step by step guide on how to use EBS Wax for rust removal:

Materials Needed:

- EBS Wax

- Safety goggles

- Gloves

- A drop cloth

- A wire brush

- Sandpaper or sanding disc

- Water

Step 1: Safety First

Before starting any rust removal process, it is important to take proper safety precautions. Rust is not only unsightly, but it also poses a health hazard if inhaled or ingested. Therefore, you must wear safety goggles and gloves to protect yourself from any splashes or fumes generated by the EBS Wax. You should also work in a well-ventilated area and place a drop cloth to prevent any accidental spills from damaging the surface around your work area.

Step 2: Prep Your Rusty Area

The next step is to prepare your rusty area by removing paint or coatings on the surface. A wire brush or sandpaper can get the job done, but using a sanding disc will be faster and more convenient. Take note that it will take more time to prepare large rusted areas, so patience is key. Once the rusted area is free of any coatings, use a damp cloth to wipe away any dirt or dust that has accumulated.

Step 3: Apply EBS Wax

Once you are done with preparing the surface, it is time to apply EBS Wax. Shake the solution well before opening it to ensure it is mixed properly. Apply the solution to the rusted area by sprinkling or pouring it onto the surface. Start with a small amount and then slowly increase it, as needed. Ensure that you wear gloves and goggles when handling this solution since it can cause skin and eye irritation. It is also recommended that you apply the solution using a brush.

Step 4: Wait and Scrub

After applying the EBS Wax solution to the rusted area, let it sit for a few minutes, then use a wire brush to scrub the treated area gently. Work on small portions at a time. Keep scrubbing until the rust has been completely removed. Be careful not to use too much force as it might damage the surface.

Step 5: Rinse Off

After removing all rust, it is time to rinse the surface with water. Use a clean cloth or sponge to wipe the area and remove any remaining residue of the product. After rinsing the surface, it is best to dry the area with a clean towel to prevent any water spots from forming. You can also use a heat gun or a hairdryer to expedite the drying process.

Step 6: Apply Protective Coating

The final step in the rust removal process includes applying a protective coating over the previously rusted area. This will prevent rust from reoccurring and prolong the life of your metal component. There are many protective coatings that you can use such as wax sealants, paints, or rust inhibitors. EBS Wax can also double up as a protective coating, ensuring your metal surfaces are protected and resistant to rusting.

Conclusion

Removing rust is a crucial step in maintaining your vehicle's look and structural integrity. With the right product, like EBS Wax, rust removal can be done quickly and effectively. However, it is always essential to take the necessary safety precautions before starting any rust removal process. Remember to prep the surface, apply the solution, scrub, rinse off, and apply a protective coating for a rust-free vehicle.